Somerset

Floor levelling in Somerset

Somerset's older houses often hide floors that slope, dip or change height between rooms. A self-levelling screed resets them to one flat surface before the new covering goes down.

Free quote · No obligation

Floor levelling in Somerset

Send a few job details for a fixed price.

Call mobile

No obligation · Same-day reply

We lay liquid and flowing screeds only. We do not offer traditional sand and cement (dry) screed.

We cover Exeter and the surrounding Devon and Somerset areas.

Or call our landline on 01392 237700

Same-day reply
Fully insured
Written quote

Why Somerset floors go out of level

Some of it is age. Brick terraces in Bridgwater and Taunton, and the stone cottages of the Mendip and Ham stone villages, have floors laid long before anyone used a laser level. Some is ground: on the soft clay and peat of the Levels, older slabs can settle unevenly over decades. And some is history, where a lean-to, a kitchen and an extension were each built at a different height and later knocked through into one room.

Getting it flat

For a dip of a few millimetres, a floor layer's smoothing compound is enough. For bigger differences, a self-levelling screed is pumped over the whole floor and finds its own level. Bonded to a sound, primed slab it can start at 25 to 30mm depending on the mix; over a membrane on a poor or damp base it goes down unbonded at 35 to 40mm. Either way the floor layer gets a true surface to work from. On a typical Somerset knock-through, the old kitchen might sit 20mm higher than the extension beside it. Rather than grinding the high side down, the usual answer is to bring everything up to one new finished level, which also hides old service trenches and patched holes.

Before anyone levels anything

If a floor on the Levels is still sinking, or cracks are opening in the walls, an engineer should look at it first. A screed corrects the surface but cannot stop movement below. In stone cottages, a breathable floor may matter more than a perfectly flat one, and then lime is worth discussing. We are happy to tell you when levelling is not the answer. Damp is the other early question: if the slab has no working membrane, an unbonded pour over a new membrane deals with it at the same time.

Rentals and refurbishments

Rented homes in Taunton and Bridgwater are often refurbished between tenancies, and stripping the old flooring can reveal a slab that would telegraph every ridge through new vinyl or laminate. A levelling pour is done in a day and walked on within 24 to 48 hours. Price depends on area, the depth needed, bonded or unbonded, access and distance; in Taunton there is no travel surcharge.

Floor levelling: Somerset coverage

Floor levelling is available across Somerset, including in Bridgwater, North Petherton, Highbridge, Burnham-on-Sea, Taunton, Wellington, Rockwell Green, Chard, Ilminster, Crewkerne, Yeovil, Wells, Glastonbury, Shepton Mallet. Every place on the Somerset page

Floor levelling in Somerset: questions

Can you level a floor in a Somerset rental between tenants?
Yes. The pour usually takes a morning, the floor takes foot traffic after 24 to 48 hours, and coverings follow once a moisture reading confirms it is ready.
Do you need the old floor covering lifted?
Yes. Carpet, vinyl and loose tiles must come up so the slab can be seen and we can decide whether to bond or lay over a membrane.
What depth does levelling need?
From about 25mm bonded with Gyvlon or 30mm with Cemfloor, and 35 to 40mm unbonded. The deepest dip in the room sets the final figure.
Will levelling raise my floor height a lot?
By at least the minimum depth of the screed, so 25mm or more. Doors, skirting and the threshold to the garden need checking before you decide.
Call LandlineGet a quoteWhatsApp