Garage Floor Screed · Somerset
Cemfloor-Certified Garage Floor Screed Across Mark
Across Mark we screed garages from 30mm bonded over sound concrete up to 50mm unbonded with insulation underneath — both finish flat and accept resin coatings cleanly.
Get a fixed price for Cemfloor-Certified Garage Floor Screed Across Mark
30 seconds. We'll come back same-day with a fixed price and next available date.
Or call our landline on 01392 237700
Across Mark we screed garages from 30mm bonded over sound concrete up to 50mm unbonded with insulation underneath — both finish flat and accept resin coatings cleanly.
We assess the existing slab, prep with shot-blasting or grinding where needed, lay edge isolation and a DPM if unbonded, then pump and level the screed in a single visit.
Most of our Mark jobs sit within 30 minutes of base, so site visits stay simple and pour days run to time. Mark sits Bridgwater (10 mi), and we work the surrounding villages on the same week's diary.
What we plan around in Mark
County
Somerset
District
Sedgemoor
Postcode
TA9
Nearest city
Bridgwater (10 mi)
Nearest motorway
M5 (J22, ~6 mi)
Primary A-road
B3139
Local industries
Levels agriculture, rural haulage
Common builds
Levels farmhouses, raised new-builds
Where liquid screed earns its keep in Mark
- Levels farmhouses — a regular brief in Mark
- Raised new-builds — a regular brief in Mark
- Converted longhouses — a regular brief in Mark
- Packhouse retrofits — a regular brief in Mark
- Levels agriculture — a regular brief in Mark
Garage Floor Screed in Mark — how it works
A typical Mark single-garage floor of 18-24m² is poured and finished in well under a morning, with the pump set up on the driveway.
We assess the existing slab, prep with shot-blasting or grinding where needed, lay edge isolation and a DPM if unbonded, then pump and level the screed in a single visit.
Specifications suited to Mark builds
Cemfloor CT-C30-F6
Cement-based screed — robust, coating-ready surface.
Bonding primer
For bonded pours over existing slabs.
DPM and slip membrane
For unbonded over insulation or older slabs.
Shot-blasting / grinding prep
Where the existing slab needs surface profile.
Floors poured around Mark
Adjacent areas — usually same-week diary
Proof from the Somerset workload
- 01Cemfloor-certified, fully insured, CDM-aware
- 02Coordinated with most South West UFH installers
- 03Pre-start meeting standard on every commercial job
- 04Local knowledge — we know the M5 (J22, ~6 mi) access window and B3139 traffic patterns
Common Mark build questions
Will it slope to a drain?+
Liquid screed self-levels — it won't form a fall. If you need a drain fall in your Mark garage, we form it in the substrate first, then screed at constant thickness.
Do you tidy up afterwards?+
Wash-out is bagged and removed. We leave the Mark site clean and the floor protected with sheeting.
Can liquid screed take an EV charger and a car's weight in Mark?+
Yes — a properly specified 40-50mm liquid screed easily handles domestic vehicle loads. We'll size the build-up to your Mark garage usage.
Can I finish the floor with epoxy?+
Absolutely — liquid screed gives you a flat, dense base that resin coatings bond to well once the screed is dry and the surface laitance is sanded off.
What about cold garages — will it cure?+
We won't pour below 5°C. For winter jobs we'll either heat the space or schedule for a mild day in your Mark diary.
Is it noisier than sand-and-cement?+
Pump day is loud for an hour or two while the truck and pump run on the driveway. After that, nothing.
Mark jobs reward proper site prep. We'll spec the build-up with your UFH installer, agree the pour window, and leave you a floor your tilers will thank us for.
Book your Mark pour
Diary fills two to four weeks ahead. Pin a date now and we'll confirm logistics.
Ready to get a price?
Tell us the rough size and location — we'll come back with a fixed quote today.
Or call our landline on 01392 237700
Related on this site